Fixed sub-bullet points.

Description/Firewall.md

@@ -17,26 +17,36 @@ This file explains the [firewall.sh](https://git.kska.io/notkshitij/scripts/src/
 1. The script shows 4 options and takes input for options from 1-4 in the `optn` variable.
 2. It uses switch case for executing commands based on selected option.
 3. Option 1 -> Home profile
+
 	- This profile is used when connected to my home network.
 	- By default all options begin by deleting the existing rules. Since I only have 4 rules max, I have used for loop from 0 to 5 (I'm aware it loops 5 times.)
 	- I did not use `sudo ufw reset` because it resets all the rules and deactivates the firewall which I did not want happening in any case.
 	- Then, it sets the default rules to allow outgoing traffic and deny incoming traffic followed by printing the output.
 	- I have then specified rules for allowing incoming traffic on port range 1714:1764 (TCP and UDP) for KDE Connect, ports 22000 (TCP) and 21027 (UDP) from `192.168.219.0/24` (my phone's IP range) for Syncthing.
 	- Lastly, it reloads the firewall and prints the verbose status.
+
 4. Option 2 -> Public profile
+
 	- This profile is used for any network other than my home network.
 	- Again, it begins by deleting any existing rules.
 	- Then, it sets the default rules to allowing outgoing traffic and deny incoming traffic.
 	- Lastly, it reloads the firewall and prints the verbose status.
+
 5. Option 3 -> Panic mode
+
 	- This profile is for rare cases where I don't want any network traffic coming in or going out.
 	- It begins by deleting any existing rules.
 	- Then, it sets the default to deny incoming and outgoing traffic.
 	- Lastly, it reloads the firewall and prints the verbose status.
+
 6. Option 4 -> Exit
+
 	- Exits the script
+
 7. Default
+
 	- For any other option number, it prints a message and ends the execution of the script.
+
 8. That's it!
 
 ---